The Magnetic Compass, the Turning and Acceleration Errors That Show Up on Every Checkride, and the ANDS Mnemonic That Only Works If You Know What to Do With It
Master magnetic compass turning and acceleration errors - including the OSUN and ANDS mnemonics - to anticipate what the compass will do before it happens.
The magnetic compass requires no power, no gyroscopes, and no electronics - just a magnetized card floating in fluid aligning itself with Earth’s magnetic field. That simplicity makes it one of the most reliable instruments in the cockpit, but it also produces predictable errors that catch pilots off guard on checkrides and in real electrical-failure scenarios.
Why Does the Magnetic Compass Show Errors?
The root cause is magnetic dip. Earth’s magnetic field doesn’t run parallel to the surface - it angles downward toward the poles. In the continental United States, that dip angle is typically between 50 and 70 degrees, depending on location. The compass card is designed to pivot horizontally, but the dipping field constantly tries to pull the card downward. That tension produces two distinct categories of error: turning errors and acceleration errors.
What Causes Turning Errors in the Magnetic Compass?
Turning errors occur when you bank the aircraft to change heading. When the aircraft banks, the compass card tilts with it, and the dipping magnetic field takes over. The card swings in the opposite direction of the turn - a left roll initially shows the compass moving right.
Turning errors are most significant on north and south headings, and nearly nonexistent on east and west headings. This is why examiners tend to ask for compass turns to north or south specifically: that’s where the error is most pronounced.
What Is the OSUN Mnemonic and How Do You Apply It?
OSUN stands for Overshoot South, Undershoot North. This describes compass behavior - not aircraft behavior - which is the key to applying it correctly.
Turning to south: The compass runs ahead of your actual heading. It will show south before you’ve arrived there. Roll out early, before the compass needle reaches south.
Turning to north: The compass lags behind your actual heading. It won’t show north until you’ve already flown past it. Hold the bank longer, letting the compass catch up.
The worst response is to react to the needle as it moves. Chasing it - overshooting, correcting, overshooting again - is exactly what tells an examiner you don’t understand the instrument. Know the error in advance and anticipate the rollout point.
How Much Do You Correct for Compass Turning Errors?
The standard rule of thumb is approximately half your latitude in degrees. Flying over Georgia at roughly 33 degrees north latitude, you’d roll out about 16 to 17 degrees early on a turn to south, and hold the bank until the compass reads roughly 343–344 degrees on a turn to north before rolling out.
The Airman Certification Standards allow ±15 degrees on the private checkride for compass turns. What the examiner is actually evaluating is whether you understand the error and are anticipating it - not whether you can nail the heading to within a degree.
What Are Acceleration Errors, and What Is the ANDS Mnemonic?
Acceleration errors occur on east and west headings when airspeed changes. The same magnetic dip that causes turning errors creates a momentary compass swing whenever the aircraft accelerates or decelerates.
ANDS: Accelerate North, Decelerate South.
- Accelerating on an east or west heading → compass temporarily swings toward north
- Decelerating on an east or west heading → compass temporarily swings toward south
When the aircraft accelerates, inertia causes the rear of the compass card to lag. The dipping field acts on that lagging card and produces a northward swing. Deceleration reverses the effect.
In practice, acceleration errors are small in most light aircraft - you won’t see dramatic swings with routine throttle changes. But this error appears frequently on the written test. A typical question: you’re in straight and level flight on a heading of 270° and you suddenly accelerate - what does the compass indicate? The answer is a turn toward north, even though the aircraft hasn’t turned at all.
When Can You Trust the Magnetic Compass?
The compass is only reliable in straight and level, unaccelerated flight. Any turn, acceleration, or deceleration introduces error. This directly governs when you can use it to sync your heading indicator.
The heading indicator is a gyroscopic instrument that precesses and drifts - it can wander several degrees over 15 to 20 minutes without correction. The procedure is to check the HI against the compass every 15 minutes during cruise, in wings-level stabilized flight, and correct as needed. Attempting to sync the HI while in a turn or while changing airspeed gives you a corrupted reference.
How Does the Compass Deviation Card Factor In?
Every aircraft has a compass deviation card, typically mounted on the instrument panel near the compass. It lists the magnetic heading required to track specific directions, corrected for the aircraft’s own magnetic interference from onboard systems and structure.
When the card tells you to steer 260° to track 257°, that’s the deviation correction at work. Brief the card during preflight and use it.
Applying This on a Checkride
When the examiner asks for a compass turn to north from a southerly heading:
- Identify north as a lag heading - the compass will undershoot
- Roll into a standard-rate bank
- Hold the bank past your gut instinct
- Apply the half-latitude correction - at 33°N, hold until the compass reads approximately 343–344°
- Roll out and allow the compass to settle
If the examiner says nothing, that’s the best possible outcome.
The compass is also not just a checkride artifact. A complete electrical failure that takes out the heading indicator leaves the magnetic compass as the primary heading reference. Knowing when to trust it, and how to read it accurately, determines whether you reach the right airport.
The FAA Pilot’s Handbook of Aeronautical Knowledge, Chapter 8 covers both error types in detail and is worth revisiting before any checkride or instrument currency flight.
Key Takeaways
- The magnetic compass requires no power but is subject to predictable errors caused by magnetic dip - the downward angle of Earth’s magnetic field
- Turning errors are greatest on north/south headings; use OSUN (Overshoot South, Undershoot North) to anticipate rollout timing
- Correct for turning errors using roughly half your latitude in degrees - roll out early for south, hold the bank late for north
- Acceleration errors occur on east/west headings; use ANDS (Accelerate North, Decelerate South) to predict compass swing
- Only sync the heading indicator to the compass during straight, level, unaccelerated flight, every 15 minutes
Radio Hangar. Aviation talk, built by pilots. Listen live | More articles