The Gimli Glider, the Air Canada Seven Sixty-Seven That Ran Out of Fuel at Forty-One Thousand Feet, and the Deadstick Landing Nobody on the Ground Saw Coming

On July 23, 1983, a metric unit conversion error left Air Canada Flight 143 with half its required fuel, forcing a deadstick landing on a closed Manitoba runway.

Aviation Historian

On July 23, 1983, a Boeing 767 carrying 169 people ran out of fuel at 41,000 feet over the Canadian Shield. What followed was not a catastrophe - it became one of the most studied examples of systemic failure and human airmanship in aviation history.

What Caused Air Canada Flight 143 to Run Out of Fuel

The aircraft, registration C-GAUN, arrived in Montreal that morning with a faulty fuel quantity indication system (FQIS). The minimum equipment list permitted the 767 to fly with an inoperative FQIS, provided fuel quantity was verified manually - by a physical dip check of the tanks using a measuring rod.

The dip check was performed correctly. The error came in converting the volume reading into weight.

Canada had recently adopted the metric system. The correct conversion factor for Jet-A fuel density is 0.803 kilograms per liter. The ramp technician used 1.77 - the imperial figure, in pounds per liter. The flight crew cross-checked the calculation using the same wrong factor. The math was internally consistent. It simply described a universe that did not exist on that ramp.

How the Numbers Compounded

Flight 143 required 22,300 kilograms of fuel for the route. Based on the flawed conversion, the crew believed they had loaded close to that figure. The tanks actually held approximately 10,100 kilograms - barely enough to reach Winnipeg from Ottawa, let alone Edmonton.

The aircraft made a planned fuel stop in Ottawa. Additional fuel was added. The same wrong conversion was used again. The crew departed Ottawa satisfied with what the numbers told them, climbing northwestbound to flight level 410.

The Moment Both Engines Failed

Captain Robert Pearson held the left seat with close to 15,000 flight hours. First Officer Maurice Quintal was on his right. Both were experienced on the 767.

At 18:13 local time, a low fuel pressure warning lit for the left engine. While the crew worked the checklist, the engine flamed out. They declared a Mayday to Winnipeg Center and began descending.

At 18:25 - twelve minutes later - the right engine quit.

The 767 had become a glider.

What Happens Inside a Widebody Airliner With No Power

The failures cascaded immediately. Bleed air dropped. Electrical systems shed in priority order. The autopilot disconnected. Hydraulic power assist on the flight controls reverted to fully manual - requiring significantly more physical force than either pilot had trained to expect from the aircraft.

The cabin went quiet in a way passengers described as deeply wrong. Emergency lighting came on. The engine noise, which passengers stop consciously registering after the first hour of a flight, was simply absent.

The Glide Path Problem

The glide ratio of a powerless 767 at their airspeeds was roughly 12:1 - twelve feet forward for every foot of altitude lost. At those speeds the aircraft was covering ground at better than four miles per minute. The altitude was burning fast.

Quintal ran the numbers for Winnipeg. They came up short. The glide path did not reach the runway. They would come down over the city.

Quintal had flown military aircraft out of RCAF Station Gimli in Manitoba, north of Winnipeg. He knew the facility had long military runways. What he could not know: the base had been decommissioned and converted into the Gimli Industrial Park Airport. And runway 32L was hosting a Winnipeg Sports Car Club racing event that afternoon - go-karts, vendor tents, families watching from the infield.

Pearson turned for Gimli.

The Sideslip That Saved 169 Lives

Coming in high with too much energy and no possibility of a go-around, Pearson made a decision that defines his record: he put the 767 into a sideslip.

A sideslip is a technique light aircraft pilots use to bleed altitude on a short final - cross the controls, present the vertical fin sideways to the airflow, create drag, come down fast. It works in a Cherokee. Pearson judged it would work in a widebody airliner.

It did. The energy came down. The 767 crossed the threshold of runway 32L.

What made that judgment available to him was something not listed in any airline pilot job description. Pearson held a glider pilot certificate. He had built energy management in unpowered aircraft - not from a textbook, but from the seat of a glider trading altitude for distance with nothing pulling it forward but its own geometry. When the approach required a pilot to feel a deadstick rather than manage one from a procedure, that skill was present.

The Landing and Its Aftermath

The nose gear had not locked down. Without hydraulic pressure it had not fully extended and seated. When the main gear touched and the nose came down, the nose gear folded. The nose of the 767 skidded forward on its own skin at better than 150 knots, dragging sparks down the runway.

The friction was violent and effective. The airplane stopped.

Emergency exits opened. Slides deployed. Race officials who ran toward the aircraft later described something they could not entirely process in real time: a large airliner had appeared over the threshold, landed without engines, and nosed into the pavement among them.

Of the 169 people aboard, 10 were injured - most during the evacuation. The collapsed nose gear had brought the overwing exits closer to the ground than the slides were calibrated for. No one died.

What the Investigation Found

The Canadian Aviation Safety Board conducted a thorough investigation. Its report identified a cascade: the maintenance deviation permitting flight with an inoperative FQIS, the incorrect conversion factor in use on the ramp, the absence of standardized metric conversion training in a recently-metrified country, and gaps in the cross-check procedure.

Any single link in that chain, broken, produces an uneventful flight to Edmonton that no one outside Air Canada ever hears about. That is how most accident chains work - and it is exactly why the culture of finding those links before they align matters as much as it does.

Captain Pearson and First Officer Quintal were initially suspended. On appeal, the suspensions were significantly reduced. The safety board’s own findings acknowledged the systemic failures that had created the conditions. The prevailing view in the aviation community holds that the institutional framework bore responsibility the initial disciplinary response did not fully reflect.

Pearson retired from Air Canada. Quintal returned to flying.

The Airplane’s Second Life

C-GAUN was repaired and returned to service. Air Canada flew the Gimli Glider for another 25 years on normal revenue routes - carrying passengers who sat in those seats with no knowledge of what the airplane had survived. It was retired in 2008 and ferried to storage in the Mojave Desert.

The story is documented in Freefall by William and Marilyn Hoffer, published in 1989. The Canadian Aviation Safety Board report is public record and worth reading in full.


Key Takeaways

  • A unit conversion error - 1.77 lbs/liter used in place of 0.803 kg/liter - left Flight 143 with approximately 10,100 kg of fuel against a required 22,300 kg
  • Both engines flamed out at 41,000 feet on July 23, 1983; right engine failure followed left engine failure by exactly 12 minutes
  • Captain Pearson’s glider pilot certificate gave him the energy management experience to execute a survivable deadstick approach in an aircraft he had no checklist for
  • A sideslip maneuver - standard technique in light aircraft, unprecedented in a widebody airliner - was what made the energy math work on final
  • All 169 people survived; the aircraft flew revenue service for 25 more years before retirement

Radio Hangar. Aviation talk, built by pilots. Listen live | More articles