Steep Turns, the Forty-Five Degree Bank Where Every Gap in Your Control Coordination Gets Exposed, and the Three Things the Examiner Is Watching From the Right Seat

Steep turns expose every gap in your control coordination - here's the aerodynamics and technique you need to pass them on checkride day.

Flight Instructor
Reviewed for accuracy by Matt Carlson (Private Pilot)

Steep turns are one of the most reliable checkride maneuvers for revealing gaps in a pilot’s control coordination. The core challenge isn’t the 45-degree bank itself - it’s understanding why the airplane behaves differently past 30 degrees and applying the right inputs before things unwind. Once the aerodynamics make sense, the technique follows naturally.

What Actually Happens to Lift in a 45-Degree Bank?

A steep turn is not simply a regular turn with more bank. Something fundamentally different happens to the aircraft once you cross 30 degrees of bank, and treating a steep turn like a steeper standard-rate turn will cost you altitude every time.

When you bank the airplane, the lift vector tilts toward the inside of the turn. Wings level, all of your lift opposes gravity. At 45 degrees of bank, only about 70% of your total lift is acting vertically - the rest is pulling you through the circle. Gravity is winning.

To maintain altitude, you must increase total lift to compensate for what you’ve lost in the vertical direction. That means increasing angle of attack. That means back pressure - more than most students expect the first time.

Why Does Back Pressure Feel Wrong at First?

The back pressure required in a steep turn feels like you’re pulling the nose up. You’re not. You’re holding it level. That distinction is critical.

Students who don’t understand this release the back pressure the moment it feels excessive, reasoning that they’re about to climb. The nose drops. They add pressure back. The whole maneuver turns into a porpoising cycle. The fix is to commit to the back pressure and trust the horizon as your primary altitude reference - not the altimeter.

How Do You Set Up a Steep Turn Before Rolling In?

Three things need to be in place before the bank.

Pick a target altitude. Most students practice between 3,000 and 4,000 feet AGL, with enough cushion below for safety and in smooth air. The Airman Certification Standards (ACS) require you to maintain altitude within ±100 feet throughout the maneuver.

Pick a target airspeed. Steep turns are flown at or below maneuvering speed (Va). In a Cessna 172, that’s typically 95–100 knots depending on aircraft weight. The ACS tolerance is ±10 knots - not much margin. Know your airplane’s specific Va from the Pilot’s Operating Handbook (POH).

Pick a visual reference point. Find a road, a lake, a town - any distinctive feature at your 3 o’clock position. This is your rollout cue. When that feature returns to your 3 o’clock, you begin rolling out. This is how you achieve a rollout within ±10 degrees of your entry heading, as the ACS requires.

How Do You Execute the Entry and Established Turn?

Roll smoothly to 45 degrees. As the bank passes through 30 degrees, begin adding back pressure - progressively, not all at once. As you approach 45 degrees, the back pressure requirement increases. Add a small power increase to maintain airspeed; the increased angle of attack has added drag. In a Cessna 172, a couple hundred RPM is typically enough.

Once established, you’re managing three things simultaneously: bank angle, altitude, and coordination.

Bank angle. Hold 45 degrees ±5 degrees. The overbanked tendency is a real aerodynamic effect: past a certain bank angle, the outer wing moves faster, generates more lift, and the aircraft wants to roll steeper on its own. Without a small amount of aileron pressure against the turn, you’ll drift to 50 or 55 degrees. Steeper bank demands more back pressure, adds more drag, bleeds airspeed, and can spiral quickly out of control. Apply light opposite aileron to hold the bank.

Altitude. Use the horizon, not the altimeter. The altimeter is a lag instrument - by the time it shows a 50-foot loss, you’ve been sinking for several seconds already. The horizon gives instantaneous feedback. Before rolling in, note where the cowling sits relative to the horizon at wings level. That nose picture is your reference throughout the turn.

Coordination. The ball in the inclinometer must be centered for the entire maneuver. Ball toward the inside of the turn means a slip. Ball toward the outside means a skid. A skid in a steep turn at low airspeed sets up the conditions for a cross-controlled stall - this is not a recoverable-with-technique situation, it’s a genuinely dangerous one. Keep the ball centered. Roll in with coordinated rudder as in any turn, then actively check and adjust throughout. Steep turns are not “set it and forget it” on the rudder.

When and How Do You Roll Out?

Start the rollout 15 to 20 degrees before your target heading. The aircraft continues turning during the rollout, so waiting until the reference point hits your 3 o’clock means rolling out 20 degrees late.

Two things happen simultaneously during rollout: reduce back pressure as the bank decreases (or the nose will climb), and ease power back toward your cruise setting if you added any during the turn. This simultaneous coordination is where many students lose the gains from an otherwise solid maneuver - they were so focused on the established turn that they forgot to track the reference point and the rollout timing.

What Is the Examiner Actually Watching?

The DPE evaluates the entire sequence, not just the established turn.

The clearing turns. Clearing the area means genuinely looking for traffic - a couple of 90-degree clearing turns or a thorough scan to both sides. A quick head swivel is not a clearing maneuver.

The entry. Is it smooth? Do back pressure and bank angle increase together, or does the nose drop first while you scramble to catch up?

The established turn. Is the bank holding at 45 ±5 degrees? Is altitude within ±100 feet? Is the ball centered?

The rollout. Did it start at the right time? Did the aircraft roll out within ±10 degrees of the entry heading?

The pilot. Are you scanning inside and outside? Are you ahead of the airplane or reacting to it? Examiners notice muscle tension, white-knuckle grip, and fixation on the instrument panel.

What Are the Full ACS Tolerances for Steep Turns?

The private pilot ACS tolerances for steep turns are:

  • Bank angle: 45 degrees ±5 degrees
  • Altitude: ±100 feet from entry altitude
  • Airspeed: ±10 knots from target airspeed
  • Rollout heading: ±10 degrees of entry heading

Students who fail steep turns on checkrides almost always fail because they never understood the aerodynamics, not because the tolerances are too tight. When you understand why the nose drops, why the overbanked tendency exists, and why back pressure increases with bank angle, the corrections come at the right time.

Do Left and Right Steep Turns Feel Different?

Yes, and you need to practice both. The ACS requires a demonstration in each direction.

In a left steep turn, propeller torque and P-factor work with the direction of turn, and coordination tends to feel more intuitive. In a right steep turn, those same forces work against the direction of turn, and some pilots find themselves working harder to hold the bank. Know both sides before checkride day - the differences are noticeable and the right turn can catch you off guard if you’ve only practiced left.

Practical Notes for Checkride Preparation

Practice rollouts until they are automatic. This is the most common place solid turns fall apart - a well-executed 360 degrees of turn undone by forgetting to track the reference point. Pick a visual reference before every single practice steep turn and reinforce it as a non-negotiable habit.

If nerves are a factor on checkride day, watch for grip tension. Tight hands produce coarse inputs. Loosen the grip. The aircraft responds better to light control pressure.

Steep turns typically click when you stop managing three separate problems - altitude, bank, coordination - and start seeing one integrated scan: nose on the horizon, ball centered, bank steady. That integration is the goal.


Key Takeaways

  • At 45 degrees of bank, only about 70% of your lift acts vertically - back pressure is essential and larger than most students expect
  • The overbanked tendency is a real aerodynamic effect; hold bank with light opposite aileron or the aircraft will roll past 45 degrees on its own
  • Use the horizon, not the altimeter, for real-time altitude control in a steep turn
  • A skidding steep turn at low airspeed can lead to a cross-controlled stall - the ball must be centered, always
  • Start the rollout 15–20 degrees before your target heading, and reduce back pressure and power simultaneously as the bank comes off
  • ACS tolerances: ±5° bank, ±100 ft altitude, ±10 knots airspeed, ±10° rollout heading

Radio Hangar. Aviation talk, built by pilots. Listen live | More articles