Loss of Communications in Controlled Airspace, the Seven-Six-Zero-Zero Squawk That Starts the Clock, and the Light Gun Signals Printed in Every Pilot Handbook That Almost Nobody Has Actually Practiced

When your radio fails in controlled airspace, squawk 7600, fly a standard pattern, and watch for light gun signals - here's the complete procedure every pilot needs to know cold.

Flight Instructor
Reviewed for accuracy by Matt Carlson (Private Pilot)

When your radio fails in controlled airspace, three things happen in sequence: you squawk 7600, you proceed to the nearest appropriate airport, and you land using light gun signals from the tower. FAR 91.185 governs every step. Most pilots know the squawk code - far fewer know what comes after it.

Is Your Radio Actually Broken?

Before declaring a communications failure, run a quick diagnostic. The majority of real-world “radio failures” are pilot error: wrong frequency selected, volume turned down, headset unplugged, or the selector switch on the wrong position.

Check the volume and squelch. Verify you’re on the right COM radio. Try a different frequency - ATIS, approach control, center. Try 121.5 MHz (guard), the emergency frequency monitored by virtually every ATC facility in the country.

Only after exhausting these checks should you treat the failure as genuine. Putting yourself through NORDO procedures on a frequency you accidentally switched off is avoidable.

What Should You Squawk for Radio Failure?

Set your transponder to 7600 immediately. This is the universal code for loss of communications.

The moment that code appears on radar, every controller tracking your aircraft sees a flag. They know what it means and they know exactly what to do. They will begin sequencing traffic away from your area, hold departures if needed, and have someone in the tower cab with a light gun tracking your position.

Also confirm your transponder is in altitude mode. Give ATC every piece of information you can - position and altitude both.

What Does FAR 91.185 Actually Require?

FAR 91.185 is the regulation that governs NORDO procedures in visual meteorological conditions (VMC). It’s worth reading in full, but the core requirement is this: continue under VFR and land at the nearest appropriate airport without delay.

“Nearest appropriate airport” does not automatically mean the towered airport you were already heading for. If an uncontrolled field is reachable and closer, the regulation makes that a legitimate option. Getting the airplane on the ground safely is the priority.

If you’re continuing to a towered airport, that’s where light gun signals take over.

What Do Light Gun Signals Mean?

A light gun is a handheld device in the tower cab that projects a focused beam of colored light - red, green, or white - in a steady or flashing pattern. For an aircraft in flight, the signals mean:

SignalMeaning
Steady greenCleared to land
Flashing greenCleared to return for landing
Steady redGive way to other aircraft, continue circling
Flashing redAirport unsafe - do not land
Flashing whiteReturn to starting point on the airport
Alternating red and greenExercise extreme caution

Don’t just read this list - quiz yourself on it. Have someone call out a color and pattern, and you say the meaning without looking. In the airplane, NORDO with traffic in the pattern and your heart rate up, that recall needs to be automatic.

How Do You Acknowledge a Light Gun Signal?

Rock your wings. That’s the standard acknowledgment for a light gun signal when you’re airborne.

When the tower gives you a steady green, rock your wings to confirm you’ve received the clearance. The controller is watching for that response. It tells them the system is working.

How Does a NORDO Arrival at a Towered Airport Actually Work?

Here is the sequence, step by step:

  1. Confirm the radio failure after running all diagnostics.
  2. Squawk 7600 and confirm altitude mode on the transponder.
  3. Decide to land at the nearest appropriate airport.
  4. Fly toward the airport and enter the standard traffic pattern - left-hand traffic on the published runway in use. Do not improvise a new approach path. Fly exactly what ATC expects.
  5. Watch for light gun signals at downwind, base, and final.
  6. Acknowledge with wing rocks.
  7. Land when you receive a steady green on final.
  8. After clearing the runway, squawk 1200 (standard VFR code) so ATC knows you’re down.
  9. Call the tower by phone as soon as you’re on the ground. This isn’t a regulatory requirement, but it closes the loop for the controllers who have been managing traffic around you.

Can You Enter Class Delta Airspace Without Radio Contact?

FAR 91.130 requires establishing two-way radio communications before operating within Class Delta airspace. But radio failure is not the same as failing to try.

If you have a genuine equipment failure and the Delta airport is your nearest appropriate landing site, NORDO procedures still apply. Squawk 7600, enter the traffic pattern, watch for light gun signals, and fly the standard pattern. ATC understands what that squawk code means and will manage traffic accordingly.

You are communicating your intentions through your actions - flying predictably, acknowledging signals with wing rocks, and landing on the designated runway. ATC is not in the dark. This is a known, trained procedure on their end.

What Is ATC Doing While You’re Flying NORDO?

Controllers aren’t waiting passively. The moment your 7600 squawk appears on scope:

  • They’re notifying other traffic in the area and sequencing them to create room for you.
  • They may hold departures to clear the runway environment.
  • Someone in the tower is tracking your position and preparing to give light gun signals at the right moments.
  • They are not panicking. Controllers train for this. The procedure is designed to work.

Your job is to hold up your end by flying predictably. Fly the standard pattern and the whole system functions the way it was designed to.

How Should You Prepare Before Flying to a Controlled Airport?

A few habits that matter:

Write down key frequencies on your kneeboard before every flight - ATIS, tower, and approach control. Not just in the GPS or the radio memory. On paper. If the radio fails mid-frequency-change, you want to be able to try every relevant frequency manually without guessing.

Note the CTAF for every uncontrolled airport along your route. If you lose radio in cruise and need to divert, those frequencies are already in hand.

Know your aircraft’s electrical system. In many training aircraft, the battery will sustain the radios for roughly 30 to 45 minutes after an alternator failure, depending on electrical load. If your ammeter is showing a discharge and you haven’t started shedding load, you have less time than you might think. Use that time to get on the ground.

How Should You Answer This Question on the Checkride?

The Airman Certification Standards require demonstrated knowledge of lost communications procedures. Examiners want more than “squawk 7600” - they want a logical, calm sequence.

A complete answer sounds like this: “I would first check for a pilot-induced cause - volume, frequency, headset connection. I would try guard on 121.5 MHz. I would squawk 7600. I would proceed to the nearest appropriate airport. If continuing to a towered airport, I would fly the standard traffic pattern, watch for light gun signals at key points in the pattern, acknowledge with wing rocks, and land when given a steady green.”

That answer covers the diagnostic, the squawk, the regulation, and the light gun procedure. It demonstrates that you understand the system, not just the code.


Key Takeaways

  • Squawk 7600 immediately upon confirming a genuine radio failure - it alerts every controller tracking your aircraft.
  • FAR 91.185 requires continuing VFR and landing at the nearest appropriate airport without delay.
  • Light gun signals replace radio contact at towered airports; a steady green on final means cleared to land.
  • Acknowledge light gun signals in flight by rocking your wings.
  • Fly a standard traffic pattern - predictable behavior is how the NORDO system works.
  • Run a full diagnostic first; most real-world radio failures are pilot error, not hardware failure.

Sources: FAR 91.185, Aeronautical Information Manual Chapter 6, Private Pilot Airman Certification Standards.

Radio Hangar. Aviation talk, built by pilots. Listen live | More articles